16
General Questions and Answers / Bias point
« on: September 13, 2016, 14:03 »
Hello
I'd put a job file on putty (ATK cluster) with 4 bias points.. If simulation is done for 3 bias points and if the cluster is stopped due to some reason the simulation starts from 0 bias.. Is there any way by which we can start from the last bias point only instead of starting all over again from 0 bias..
Thanks & Regards
I'd put a job file on putty (ATK cluster) with 4 bias points.. If simulation is done for 3 bias points and if the cluster is stopped due to some reason the simulation starts from 0 bias.. Is there any way by which we can start from the last bias point only instead of starting all over again from 0 bias..
Thanks & Regards