QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: rose on June 11, 2020, 15:56

Title: Question on using gate voltage
Post by: rose on June 11, 2020, 15:56

Hi,
I am trying to simulate the following paper for the sake of learning,
https://doi.org/10.1002/adfm.201402904

I can regenerate Figure 2 in this paper and it perfectly matches, however, I can not regenerate the Figure 3d results.

While the transport in Vg=0 is achieved properly, the results in Vg=20 is not regenerated. I also check for Vg=40V but still, nothing can get similar to the mentioned paper also checked both Drikhle and Newman's condition in the gate direction but still not get any match for gate voltages. I read most of the tutorials on the gate voltage but can not understand why I can not regenerate the voltage gate results.

 I attached the input file. I would wonder if it would be possible to guide me to find my mistake.
sincerely
Rose