QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: fangyongxinxi on December 22, 2009, 16:23

Title: How to set electrodes for “big ” center ?
Post by: fangyongxinxi on December 22, 2009, 16:23

Dr Sir,
     I have read a short introduction about ATK2008 in Chinese. In this introduction an example is abtout the DOS of ZnO “big” nanowire ( more than 200 atoms ) calculated by ATK.
     My question is If this DOS is calculated in the form of TwoProbe calculation, how to set the electrodes for the big nanowire ? build a bigger electrode , or set “ part of the wire” as the electrodd like the Ａｌ wire did in the manule of ATK2008.

Thank you.

Title: Re: How to set electrodes for “big ” center ?
Post by: Nordland on December 22, 2009, 18:54

I think it is done as a part of the wire.