QuantumATK Forum
QuantumATK => General Questions and Answers => Topic started by: shyoun on June 9, 2023, 08:17
-
Dear Staffs and Users,
I installed a new version of QuantumATK and tried connecting to another server.
I have confirmed that it works fine on a server where the license is already installed.
The problem is when trying to connect to the server license from another server.
Could you please tell me what information should I put in these blanks(hostname&port)?
Regards
-
Just put the ip address of QuantumATK server in the Hostname section and connect. Leave other two sections as it is.
-
Thank you for your answer!
Does 'ip address' mean the address that comes out with '$ ip addr' or '$ ifconfig' commands in the terminal of the server with license?
I actually already tried it, but it doesn't work.
Is there any information I need to enter other than xxx.xxx.xxx.xxx?
Thank you.
-
You got it correct and no need to enter other things, only ip address needed. The commands you wrote may sometimes provide multiple ip addresses so you have to really check or contact the System Admin to get the correct ip address of the quantumatk server. Also make sure to disable firewalls at both end.