QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: John on March 13, 2011, 16:28

Title: losing the configure when displaying the LDOS
Post by: John on March 13, 2011, 16:28

Dear Sir,
    For the ATK11.2 version, it seems unable to display the device or two-probe configure when viewing the LDOS. It could be better to control the display of configure,not only the space distribution of real-space density of states.
    Thanks.

Title: Re: losing the configure when displaying the LDOS
Post by: Nordland on March 13, 2011, 23:43

Try re-dropping the configuration on open viewer with the LDOS in it.?

Title: Re: losing the configure when displaying the LDOS
Post by: John on March 14, 2011, 02:34

Thank you  Nordland. The configure can be displayed with the LDOS by your method, but the radius  (atom or bond) of the configure seems unable to be controled, beacuse it only shows "The composite plot takes no parameters" for "Device configure" when  controling the display of LDOS.
   Thanks, do you have more advice to control the configure.

Title: Re: losing the configure when displaying the LDOS
Post by: Nordland on March 14, 2011, 08:55

Next to the plot, there is a small tab/arrow showing that this tab is expandable. Under this you will again find three expandable tabs where you can set the parameters for the device configuration.

Title: Re: losing the configure when displaying the LDOS
Post by: John on March 15, 2011, 03:20

Thank you Norland, It works fine by your method although only the device configure can be controled, but the left or right leads not.