QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: jerry on November 12, 2011, 06:49

Title: Install problem in ATK 11.8.0
Post by: jerry on November 12, 2011, 06:49

Dear,
   
     I installed the ATK11.8.0, when i run this version, something goes wrong. Set minimum Size: (Qlabel) negative Sizes (-1, -1) are not possible. But ATK can still run.

Title: Re: Install problem in ATK 11.8.0
Post by: Anders Blom on November 12, 2011, 21:16

We've seen a few error messages reported by Qt in release mode. In most cases they are not critical, but we'll keep a close eye on them. It would help if you could figure out at what precise moment the error is displayed, exactly what you do to trigger it (and if it's reproducible).

Title: Re: Install problem in ATK 11.8.0
Post by: jerry on November 13, 2011, 03:17

This error message occurs every time when i start the ATK from the terminal (redhat). By the way, i have sent you an email on the molecular junction calculation privately, because the results have not been published. Waiting for your informative reply and kind help!

Title: Re: Install problem in ATK 11.8.0
Post by: Anders Blom on November 13, 2011, 22:16

Which Redhat, exactly? And which graphics card? We have a test machine running Redhat, so we can check on that too.

Title: Re: Install problem in ATK 11.8.0
Post by: jerry on November 15, 2011, 08:37

The os i use is redhat enterprtse 6.0 for server (x86_64). The graphic card is NVIDIA GTX 280.