QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: njuxyh on June 15, 2014, 19:20

Title: how to use old calculation file to specify the initial spin
Post by: njuxyh on June 15, 2014, 19:20

Hi all:

i want to know, how to use old calculation file to specify the initial spin?

 what is the file format? or just old calculation * py file or *.nc file?


thanks very much!

Title: Re: how to use old calculation file to specify the initial spin
Post by: Mehboob on June 16, 2014, 07:32

While preparing for the input just select the use old calculation (in initial spin section) and specify the full path and file name of the .nc file of the previous job done (from which you want to take the initial spin).

Regards,
Mehboob