QuantumATK Forum

QuantumATK => Scripts, Tutorials and Applications => Topic started by: simba on October 6, 2009, 23:55

Title: Problem viewing output of script on custom builder
Post by: simba on October 6, 2009, 23:55

I have opened Graphene junction device using custom builder i got the script of junction device by dragging and dropping it  on script editor, but when i drag and drop the same script on custom builder i get nothing. if i modify some values of the geometry it returns me an error in the log window.  please tell me if it is error on my side or is it limitation of this version.
Thanks in advance.

Title: Re: Problem viewing output of script on custom builder
Post by: Anders Blom on October 7, 2009, 02:24

There is no sense in dragging the script to the Customer Builder, the only scripts you drop on the CB itself are scripts that setup a new Builder. What are you trying to achieve?

As for the errors, probably you try to have too few surface repetitions. There must be at least as many as there are electrode repetitions, this is a general requirement in the model.

Title: Re: Problem viewing output of script on custom builder
Post by: simba on October 7, 2009, 03:31

I want to modify graphene structure slightly and observe the impact it has on the IV characteristics.

Title: Re: Problem viewing output of script on custom builder
Post by: Anders Blom on October 7, 2009, 03:34

At this point, you best option for that is unfortunately to do it by hand, in the script itself. Better tools for these kinds of manipulations will be available in later releases, of course.