QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: namrata on November 8, 2009, 10:56

Title: what is default meshcutoff???
Post by: namrata on November 8, 2009, 10:56

if i do not specify mesh cutoff in atk 2008.10 scf calculation input file even then the scf calculation gets executed and scf.nc file is generated . what is the default value of mesh cutoff  taken into consideration ???

Title: Re: what is default meshcutoff???
Post by: Anders Blom on November 8, 2009, 16:05

150 Ry.

All default values of parameters are listed in the manual, in this case here: http://quantumwise.com/documents/manuals/ATK-2008.10/ref.electrondensityparameters.html

Title: Re: what is default meshcutoff???
Post by: namrata on November 14, 2009, 11:25

thanks a lot