QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: SAKINA on February 19, 2017, 05:30

Title: bending AGNR
Post by: SAKINA on February 19, 2017, 05:30

Hi
I have been following exploring graphene and applied the same method in obtaining bending AGNR with various of wraping angle. But I found that below that 180 degree , the bending cannot be noticed and during 360 degree the AGNR does not formed a tube.  Is it possible not to form a tube during 360 degree? The figure below I attached is when the AGNR has been wrap at 360 degree.

Title: Re: bending AGNR
Post by: zh on February 19, 2017, 07:46

The length of ribbon may too short, so it couldn't be bent into a tube by 360 degree.

Title: Re: bending AGNR
Post by: SAKINA on February 19, 2017, 09:44

Thank you for your reply. But I have tried to use much wider width of AGNR up to 30 and it still does not formed tube. I attached the figure of 30-AGNR being wrap at 360 degree. Is there any reason why  AGNR will not form tube by applying 360 degree?
Thank you