QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: Roc on July 12, 2009, 02:45

Title: Error in removing file？
Post by: Roc on July 12, 2009, 02:45

Dear everyone，

   When I calculate the transport properties of my two-probe system, one error happens.
when the bias voltage is increased to 0.7V, and "Restore self consistent calculation from check point file " using the .nc file that of 0.6V,the errro happens like that,

# Error in removing file [au-Mol-au07.nc]: Permission denied
#  Warning : Could not rename file D:\AYP\QuantumWise\ATK 2008.10\bin\_au-Mol-a
u07_HCOIJC.nc to au-Mol-au07.nc !

Surprisingly, all the calculated physical properties have been obtained successfully!
thanks!

Title: Re: Error in removing file？
Post by: Nordland on July 12, 2009, 09:04

Hey anyipeng.

It is mostly an unharmfull warning due to the fact that the operating system or antivirus program is inspecting the file as it gets generated,
and therefore ATK is not allowed to move it.

It will only lead to a problem if this happens many times during a calculation :)

Cheers,
   Nordland.

Title: Re: Error in removing file？
Post by: Anders Blom on July 13, 2009, 09:59

If this becomes a real problem, you may want to instruct your antivirus software to ignore files with the ".nc" extension.

Title: Re: Error in removing file？
Post by: Roc on July 15, 2009, 06:21

Ok,Thank you very much.
Maybe like you said. ;D