QuantumATK Forum

QuantumATK => General Questions and Answers => Topic started by: mjavani on July 22, 2020, 00:49

Title: Job Manager won't work
Post by: mjavani on July 22, 2020, 00:49

Hello,
I have been working with QuantumATK 2019, and recently experienced some problem as follows:
I start the application, and by using Builder, I built my structure. Then I go to Script Generator and add calculation Optimization and Analysis to the simulation. Finally, I try to run it. This is the part that I have a problem with. After I click on Job Manager, it never goes to the Job Manager page to run the simulation. Could you please give me some advice to resolve this issue. Thank you,

Title: Re: Job Manager won't work
Post by: MrJo on July 23, 2020, 13:45

Dear mjavana,

I once had a similar problem. The job manager would not open anymore and there appeared an error message stating "list index out of range". In another forum discussion I read that this could be related to a corrupted file of the Job manager. The job manager stores the job list and some related information in a file.

If you navigate to your folder on the linux system, you should find a hidden folder called .vnl. In this folder, the job manager places an hdf5 file called Jobs_2019.12.hdf5 in my case. Of course, it might be named different, if you use a different version of QuantumATK. Deleting this file has solved my problem. The job list was deleted then and the Job manager could be opened again. I recommend you to rename the file or moving it somewhere else, before you delete it. Maybe, this will solve your problem.

Best Regards

Title: Re: Job Manager won't work
Post by: mjavani on July 25, 2020, 01:33

Dear MrJo,
Thank you so much, it works.

Title: Re: Job Manager won't work
Post by: mashru on August 5, 2020, 17:58

Hello everyone,

I am facing the same issue in 2019.12 version in windows platform. Is the process same in the windows version or is there any changes.
Thanks in advance.

Title: Re: Job Manager won't work
Post by: Pieter Vancraeyveld on August 7, 2020, 14:22

The procedure on Windows is the same.

Title: Re: Job Manager won't work
Post by: malay srivastava on September 29, 2020, 01:01

Delete the .hdf5 file in .vnl folder. It will work!