Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - neerja

Pages: [1]
Questions and Answers / charge point defect
« on: February 8, 2020, 08:35 »
hello everyone,
i have made supercell of tio2  and doped with non metal and i want to calculate formation energy for ti -rich and o-rich condition. for that i need to specify chemical potential of ti and o. so how to specify ti and o  chemical potential in order to get ti or o rich condition  using charge point defect.

hello everyone,
I want to calculate the formation energy for co doped supercell. I have made supercell of Tio2  and i want to doped it by substituting one V in place of Ti and one N atom in place of O atom. so i don't know how to get formation energy for it using quantum atk. i have gone through the tutorial on formation energy calculation for GaAs.  can i follow the same procedure for codoped supercell. because tutorial is given for single atom  substitution. or we need to calculate formation energy manually using following formula

General Questions / Surface slab calculation
« on: December 26, 2019, 07:03 »
hi everyone,
I m working on brookite TiO2. i want to calculate the properties for diffrent low index surfaces of brookite TiO2. also want to study surface termination effect.  so i want to know how to make oxygen terminated slab and ti terminated slab in quantum atk 2018.03

hello everyone,
 i want to know the procedure for lattice constant minimisation after getting optimised structure in quantum atk for orthorhombic crystal.

hello everyone,
  I m new user of this software. i just want to know how to optimize the crystal structure , how to calculate density of state and total energy for crystal. specially i  want to know how to do these for vanadium oxide.
  thank u...

Pages: [1]