76
General Questions and Answers / Re: Optimization issue
« on: September 22, 2022, 01:23 »
Can any one guide me, what's the issue in the input file?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
77
General Questions and Answers / Optimization issue
« on: September 21, 2022, 00:47 »
I have been facing alot of problem while optimizing the device calculations. It takes even a week but it didn't converged. Here in, I attached the input file. May be there is an issue in the input file. Can some suggest me ?
I have attached the pdf file for my input. Can someone look into it and suggested me what's wrong in it due to which I am unable to get result for optimized geometry and Device optimized geometry.
I have attached the pdf file for my input. Can someone look into it and suggested me what's wrong in it due to which I am unable to get result for optimized geometry and Device optimized geometry.
78
General Questions and Answers / Re: Transmission spectra vs k-points
« on: September 15, 2022, 01:20 »
Thank you so much for your response.
I tried alot to figure out why there is peak at fermi level, but I couldn't find the suitable analysis to understand this.
As mentioned in the above messages, my system is 1-D stanene nanoribbons and Pd is adsorbed on the central region but I found "with and without Pd" there is peak at fermi level. What analysis should I do to figure out this peak?
Secondly, how to find out that this lenght of central region would be for analysis, or I should randomly changed the central region lenght and then figure it out.
Thank you
I tried alot to figure out why there is peak at fermi level, but I couldn't find the suitable analysis to understand this.
As mentioned in the above messages, my system is 1-D stanene nanoribbons and Pd is adsorbed on the central region but I found "with and without Pd" there is peak at fermi level. What analysis should I do to figure out this peak?
Secondly, how to find out that this lenght of central region would be for analysis, or I should randomly changed the central region lenght and then figure it out.
Thank you
79
General Questions and Answers / Re: Transmission spectra vs k-points
« on: September 2, 2022, 01:43 »
Thank you very much. Now, It's clear for me.
I have attached the PDOS vs Transmission spectrum for Pd adsorbed on 1-D stanene nanoribbon for device calculations.
I have attached the PDOS vs Transmission spectrum for Pd adsorbed on 1-D stanene nanoribbon for device calculations.
80
General Questions and Answers / Re: Transmission spectra vs k-points
« on: August 31, 2022, 00:31 »
Thank you for your guidance
As mentioned earlier, for 1×1 k point in transmission spectrum there is broad peak at fermi level. What is the signifance of this peak.For 1-D, transmission spectrum are independent of k point in the tranverse direction then why there is broad peak at fermi level.
In manual, it is mentioned that for a perfect 1D system, the transmission exhibits a sequence of steps with integer transmission. I couldn't understand this.
For 2-D, transmission spectrum dependent on k point? Why
Can you please explain me?
As mentioned earlier, for 1×1 k point in transmission spectrum there is broad peak at fermi level. What is the signifance of this peak.For 1-D, transmission spectrum are independent of k point in the tranverse direction then why there is broad peak at fermi level.
In manual, it is mentioned that for a perfect 1D system, the transmission exhibits a sequence of steps with integer transmission. I couldn't understand this.
For 2-D, transmission spectrum dependent on k point? Why
Can you please explain me?
81
General Questions and Answers / Transmission spectra vs k-points
« on: August 30, 2022, 12:28 »
I am doing research in 1-D stanene nanoribbon for device calculation and interested to optimize the Pd on it.
I want to know what is the role of k-point in transmission spectra of 1-D stanene nanoribbons, I have chosen 1×1 and 9×9 k-points but couldn't get the desired results for transmission spectra.
I want to know what is the role of k-point in transmission spectra of 1-D stanene nanoribbons, I have chosen 1×1 and 9×9 k-points but couldn't get the desired results for transmission spectra.