« previous next »
Pages: [1]   Go Down

Author Topic: Spiral CNT  (Read 3752 times)

0 Members and 1 Guest are viewing this topic.

Offline ams_nanolab

  • Supreme QuantumATK Wizard
  • *****
  • Posts: 389
  • Country: in
  • Reputation: 11
    • View Profile
Spiral CNT
« on: July 19, 2017, 12:38 »
Hi, I want to make a spiral CNT (rolled up graphene) structure, but can't do with the builder in ATK 2016.4. I tried with the tube wrapper plugin but it's not working properly. Kindly help.
Logged

Offline Jess Wellendorff

  • QuantumATK Staff
  • Supreme QuantumATK Wizard
  • *****
  • Posts: 933
  • Country: dk
  • Reputation: 29
    • View Profile
Re: Spiral CNT
« Reply #1 on: July 19, 2017, 15:36 »
Why don't you just use the Nanotube Builder and select the proper chirality? (see attached png)
Logged

Offline ams_nanolab

  • Supreme QuantumATK Wizard
  • *****
  • Posts: 389
  • Country: in
  • Reputation: 11
    • View Profile
Re: Spiral CNT
« Reply #2 on: July 20, 2017, 11:55 »
What I want is something different. The open end to look like a rolled up carpet/ swiss roll.
Logged

Offline Anders Blom

  • QuantumATK Staff
  • Supreme QuantumATK Wizard
  • *****
  • Posts: 5576
  • Country: dk
  • Reputation: 96
    • View Profile
    • QuantumATK at Synopsys
Re: Spiral CNT
« Reply #3 on: July 20, 2017, 19:04 »
First of all you will need a very broad sheet to do that, but I believe setting the angle to > 360 degrees might work. Not sure the plugin supports very high values, you may need to edit the source code to allow you to enter a very large angle.
Logged
Pages: [1]   Go Up
« previous next »