Author Topic: Is Planewave PAW Spin Orbit Coupling not supported?  (Read 4617 times)

0 Members and 1 Guest are viewing this topic.

Offline pshinyeong

  • Heavy QuantumATK user
  • ***
  • Posts: 38
  • Country: kr
  • Reputation: 0
    • View Profile
I tried running Planewave PAW SOC but the calculation is run without SOC.
Is it because it is not supported?

Thanks

Offline filipr

  • QuantumATK Staff
  • Heavy QuantumATK user
  • *****
  • Posts: 82
  • Country: dk
  • Reputation: 6
  • QuantumATK developer
    • View Profile
Re: Is Planewave PAW Spin Orbit Coupling not supported?
« Reply #1 on: July 12, 2024, 20:09 »
Planewave PAW supports SOC. Can you share the script you are trying to run?

Offline pshinyeong

  • Heavy QuantumATK user
  • ***
  • Posts: 38
  • Country: kr
  • Reputation: 0
    • View Profile
Re: Is Planewave PAW Spin Orbit Coupling not supported?
« Reply #2 on: July 15, 2024, 08:54 »
Hello,

I went through the script and found out it was my mistake. However though, there seem to be problem in the workflow, whenever PW PAW SOC is selected, the workflow can't be saved and the following error message appears (screenshot attached). 



++
I am using 2023.12 version and I wasn't trying to load workflow from an older version.
The workflow was created within 2023.12 version
« Last Edit: July 16, 2024, 02:14 by pshinyeong »

Offline filipr

  • QuantumATK Staff
  • Heavy QuantumATK user
  • *****
  • Posts: 82
  • Country: dk
  • Reputation: 6
  • QuantumATK developer
    • View Profile
Re: Is Planewave PAW Spin Orbit Coupling not supported?
« Reply #3 on: August 6, 2024, 11:14 »
Ok, this has been confirmed to be a bug.

As a workaround until it is fixed I suggest that you don't save the workflow, but instead save it has a script and run the script.