« previous next »
Pages: [1]   Go Down

Author Topic: conductance  (Read 2370 times)

0 Members and 1 Guest are viewing this topic.

Offline naash

  • Regular QuantumATK user
  • **
  • Posts: 12
  • Reputation: 0
    • View Profile
conductance
« on: June 26, 2011, 14:28 »
question 1
what does the id values in conductance curve stand for?

2) i calculated an IV curve and out of it i analyzed the conductance but the conductance curve does not start from 0 on the id values it starts some where around 1 is it correct?

3) what are the best boundary conditions to use when optimizing bulk devices is it ok to use the Iteration Control Settings?

looking forward for positive response
thanks in advance
Logged

Offline zh

  • QuantumATK Support
  • Supreme QuantumATK Wizard
  • *****
  • Posts: 1141
  • Reputation: 24
    • View Profile
Re: conductance
« Reply #1 on: June 28, 2011, 15:10 »
Quote from: naash on June 26, 2011, 14:28
3) what are the best boundary conditions to use when optimizing bulk devices is it ok to use the Iteration Control Settings?
looking forward for positive response
thanks in advance

The periodic boundary conditions is more suitable for the bulk devices.  The iteration control settings are not related to the problem of boundary conditions.
Logged
Pages: [1]   Go Up
« previous next »