Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bera.1

Pages: [1]
1
Hi,
I need a help from quantumwise experts.
When I do a device calculation with Gold as electrodes and MoS2 as channel with a dielectric of k=4 and a metallic gate of 0.5 volt, the scf calculation is not converged when I apply a electrode voltage of 2 volt or higher than 2 volt. There is no problem in convergence upto 1.75 volt. For higher voltage greater than 1.75 volt I am facing the convergence problem.
So please help me in this issue. I appreciate you for your valuable suggestion.
Regards,
Jayanta

2
Thank you very much Ulrik G. Vej-Hansen for your valuable suggestion.
Yes the device is converged at zero bias with gate and dielectric but there is problem when i am changing dielectric constant to a higher value.

3
I am facing a problem in ATK when I am using a metallic gate and dielectric into a device with gold as right and left electrodes and MoS2 monolayer as a channel material. When I calculate zero bias transmission spectra and I-V characteristics of two terminal device that is without adding metallic gate and dielectric the calculation is converged and I get I_V curve. But when I add a metallic gate with gate voltage -1volt and dielctric of dielectric constant=4 then some points are not converging. And when I change the dielectric constant to a value of 9 and 25 then no points are converging and my calculation stops.
I have done same calculation with DTB molecules as a channel and also test for graphene with adding gate and dielectric then there is no problem in calculation and I have got I-V curve correctly.
So is there any problem with MoS2 in ATK?
Please help me in this issue.

Pages: [1]