Messages

1

General Questions and Answers / Re: MOS2 Slater Koster

« on: May 1, 2014, 17:45 »

I appreciate your patience !

I will try re-simulating a bigger device with increased k - points. Let's hope that works

Thanks!

2

General Questions and Answers / Re: MOS2 Slater Koster

« on: April 30, 2014, 22:17 »

Dr Anders,

I tried your suggestion by including the gate within the unit cell. Still no change in results, attached is my script.
Can you please look into it.

Thanks!

3

General Questions and Answers / Re: MOS2 Slater Koster

« on: April 29, 2014, 20:03 »

Anyone !

4

General Questions and Answers / Re: Id-Vd/Id-Vg curves for different values of Vg and Vd

« on: April 28, 2014, 19:37 »

Adila,

Were you able to get a curve for VGS sweep only VDS=constant? I am facing problem with that.

Thanks !

5

General Questions and Answers / Re: MOS2 Slater Koster

« on: April 28, 2014, 02:12 »

Dear Dr. Anders,

Attached is the script. Kindly have a look.

Following are some trial I made based on your previous comments on forum:

1. Periodic(since unit cell has enough vacuum), Periodic , Dirichlet boundary
2. Neumann, Periodic, Dirichlet Boundary
3. Single gate vs dual gate

 I was able to get correct bandgap, but wasn't able to see effect of gate voltage.
I am stuck any help is appreciated!

6

General Questions and Answers / Re: MOS2 Slater Koster

« on: April 27, 2014, 05:07 »

Dear Quantumwise Staff,

Any suggestion on why gate voltage doesn't seemto have any effect?

Thanks!

7

General Questions and Answers / Re: MOS2 Slater Koster

« on: April 23, 2014, 19:56 »

Thanks Shinji!

I tried both your suggestions, still I get Bandgap of 2.2eV instead of 1.8eV.

I used DFT and I have the correct bandgap. But I see something weird. On application of gate voltage. The transmission spectra doesn't change. From what I believe transmission must shift up or down depending on polarity of gate voltage. I tried both single gate and dual gate (Vdd and 0 volt) but can't see any shift only the peaks of transmission shifts downwards.

As such when I calculate I-Vgs I would get a flat curve instead of typical saturating curve. Any suggestion is appreciated.

Thanks !

8

General Questions and Answers / MOS2 Slater Koster

« on: April 22, 2014, 19:26 »

Hi Quantumwise Staff,

I was following this paper http://arxiv.org/pdf/1401.4553.pdf

The authors have used ATK to get DOS and they claim the bandgap turns out to be 1.8eV (see first line under results and discussions).This bandgap is in agreement with published literature.

I was trying to reproduce the DOS, my DOS agrees qualitatively (as in the shape) but the bandgap I end up getting is ~2.2eV.

Can someone look at my attached script and let me know if I have missed something. I don't want to go for more rigorous DFT or Huckel if Slater-Koster(as claimed in paper) works

Regards!