« previous next »
Pages: [1]   Go Down

Author Topic: bending AGNR  (Read 3054 times)

0 Members and 1 Guest are viewing this topic.

Offline SAKINA

  • Heavy QuantumATK user
  • ***
  • Posts: 26
  • Country: my
  • Reputation: 0
    • View Profile
bending AGNR
« on: February 19, 2017, 05:30 »
Hi
I have been following exploring graphene and applied the same method in obtaining bending AGNR with various of wraping angle. But I found that below that 180 degree , the bending cannot be noticed and during 360 degree the AGNR does not formed a tube.  Is it possible not to form a tube during 360 degree? The figure below I attached is when the AGNR has been wrap at 360 degree.

Logged

Offline zh

  • Supreme QuantumATK Wizard
  • *****
  • Posts: 1141
  • Reputation: 24
    • View Profile
Re: bending AGNR
« Reply #1 on: February 19, 2017, 07:46 »
The length of ribbon may too short, so it couldn't be bent into a tube by 360 degree.
Logged

Offline SAKINA

  • Heavy QuantumATK user
  • ***
  • Posts: 26
  • Country: my
  • Reputation: 0
    • View Profile
Re: bending AGNR
« Reply #2 on: February 19, 2017, 09:44 »
Thank you for your reply. But I have tried to use much wider width of AGNR up to 30 and it still does not formed tube. I attached the figure of 30-AGNR being wrap at 360 degree. Is there any reason why  AGNR will not form tube by applying 360 degree?
Thank you
Logged
Pages: [1]   Go Up
« previous next »