Dear everyone,
i am calculating the I-V curve following the I-V curve and voltage drop tutorial,and i did the scf calculation for each bias voltage, and stored the nc file seperately. In the scf calculation, I used krylov as device algorithm.
And in the step of computing the transmission and voltage drop for each case, I used the script and changed it a little bit according to the notes. The only thing I am worrying about is : I didn't find the device algorithm in the analysis script, and it only shows up as the configuration.calculator, and I just leave it as it is.
I am not sure if it's still using krylov algorithm? Cause it's really very slow in this step.
