« previous next »
Pages: [1]   Go Down

Author Topic: Unit Cell size  (Read 4676 times)

0 Members and 1 Guest are viewing this topic.

Offline Nayab Shiraz

  • Heavy QuantumATK user
  • ***
  • Posts: 51
  • Country: us
  • Reputation: 0
    • View Profile
Unit Cell size
« on: July 1, 2020, 23:36 »
How to select the size of unit cell? I assume enough vacuum around the actual structure is needed. If my results change with change in size of unit cell, do I need to keep increasing the lattice parameters for convergence?
Logged

Offline mlee

  • QuantumATK Guru
  • ****
  • Posts: 173
  • Country: dk
  • Reputation: 7
    • View Profile
Re: Unit Cell size
« Reply #1 on: July 3, 2020, 08:18 »
If you need to confirm the vacuum size around the actual structure, you can analyze the HatreeDifferencePotential or ElectrostaticDifferencePotential to see the convergence. 
Logged

Offline Nayab Shiraz

  • Heavy QuantumATK user
  • ***
  • Posts: 51
  • Country: us
  • Reputation: 0
    • View Profile
Re: Unit Cell size
« Reply #2 on: July 4, 2020, 20:41 »
Thank you so much. Do you mean that these quantities should not change with further increase in size?
Logged

Offline mlee

  • QuantumATK Guru
  • ****
  • Posts: 173
  • Country: dk
  • Reputation: 7
    • View Profile
Re: Unit Cell size
« Reply #3 on: July 6, 2020, 06:55 »
You will see the convergence (constant) near the boundary through the HartreeDifferencePotential or ElectrostaticDifferencePotential analysis if it has proper vacuum length.
Logged
Pages: [1]   Go Up
« previous next »