Author Topic: Polyimide not available in database  (Read 522 times)

0 Members and 1 Guest are viewing this topic.

Offline Par_Navidi

  • New ATK user
  • *
  • Posts: 1
  • Country: ca
  • Reputation: 0
    • View Profile
Polyimide not available in database
« on: December 5, 2021, 22:44 »
I would like to determine the resistivity of the 2D polyimide (kapton) thin film as a function of the applied stress and induced defects. I have the following problems:
1) I can not find the 3D structure of the polyimide in the database. I was only able to find a 2D structure at some websites…How can we have access to such chemical structures?
2) for a 20 nm-thick thin film of polyimide (50 layers of polymer) how I should consider the orientation of the polymer chains in the confined direction? Does the interactions changes the resistivity of the material?

Offline mlee

  • ATK Guru
  • ****
  • Posts: 173
  • Country: dk
  • Reputation: 6
    • View Profile
Re: Polyimide not available in database
« Reply #1 on: December 6, 2021, 09:45 »
The below link will guide how to build the polymer.

Offline BradWells

  • QuantumATK Staff
  • New ATK user
  • *****
  • Posts: 9
  • Country: dk
  • Reputation: 0
    • View Profile
Re: Polyimide not available in database
« Reply #2 on: December 7, 2021, 09:34 »
Hi Par_Navidi,

In QuantumATK, you are able to build and import your own monomers into the Monomer Database.  In this case you can build a monomer of kapton in the builder.  Remember to tag the head and tail atoms so that the Polymer Builder knows how to connect the monomers to form a chain.  Using the imported monomer you should be able to use the Polymer Builder to create a 3D amorphous structure of kapton. If your material is crystalline and you know the crystal structure, you can also import CIF files into the Builder.

With respect to the thin film part of your problem, the Polymer Builder packs polymer chains into the simulation cell with isotropic orientations.  It currently doesn't support aligning the polymer chains along a particular axis.  On the scale of atomic simulation 20nm is quite large, so it may be necessary to consider the material as continuous in all directions and then apply stress in particular directions.